How to Reset the Windshield Wipers

1. Remove the plastic cover between the hood and the windshield that hides the wiper motors and arms. The cover is held in place with clips. Insert a pry tool, such as a standard screwdriver behind the cover and gently twist to pop it out of place. Set the cover aside.
2. Use a socket wrench to remove the nut located at the center of the wiper motor. This nut connects the arm linkage to the motor. Turn the wipers on, then back off, so the motor completes a full cycle and returns to the correct park position. The blades will not move since the linkage has been disconnected.
3. Position the wiper blades in the correct park position. They should rest horizontal and parallel to the windshield. Push the wiper linkage back onto the motor and replace the nut. Tightly secure it with the socket wrench.
4. Turn the wipers on to test them. They should sweep the windshield as normal, then return to the park position at the bottom of the windshield. Replace the plastic wiper cover by pressing it into position until the clips snap back in.