How to Change a Turn Signal Light on a BMW


How to Change a Turn Signal Light on a BMW
1. Pop the hood on the car and use the flashlight to locate the four separate bolts that fasten the given light on the front of the car.
2. Loosen all four easily-seen bolts using the socket wrench and place bolts to the side taking care to remember which bolt goes where.
3. Once the bolts have been removed from the car, carefully yet firmly pull the entire lighting unit toward you. (The side marker light has a separate clip and you must apply slightly more pressure to that side of the light to get it loose from the vehicle.)
4. With the light pulled roughly six inches from the car, carefully loosen the bulb housing unit on the defective turn signal.
5. After removing the bulb, place the new bulb in the socket and gently turn slightly to the left while pushing down. This action will cause the bulb to slide down into the given slots on the housing unit.
6. After securing the bulb, make sure to turn your emergency lights on to see if the bulb is working.
7. If the bulb works, carefully slide the light back into place by applying an equal amount of pressure to the entire housing unit.
8. After the light has been slid firmly back into place, tighten the bolts back into their given grooves and close the hood.