How to Change Fog Lights on an Audi A6


1. Park your Audi A6 somewhere suitable. The ground should be level, and you should have adequate light to work by.
2. Locate the plastic access panel to the side of the fog light that needs repair. Get down low and look to the outside edge of the fog light. It is held on by two clips that can be snapped open with a slotted screwdriver.
3. Unscrew the four Philips screws holding the fog light assembly to the bumper. Pull the assembly free gently to gain enough room to reach the bulb itself. It will have wires attached to the rear, so be sure not to disconnect these while pulling the assembly out.
4. Push the bulb in slightly, and turn it to the left to remove it. Then take a replacement bulb No. H7 and insert it into the assembly. Reassemble the fog light in the reverse order you took it apart.