How to Program an Infiniti G20 Garage Door Opener

1. Turn your vehicle's ignition off and press and hold the two outside buttons on your Infiniti system until the indicator light begins to flash. This will erase any previously programmed codes from the system.
2. Hold your garage door remote 2 inches from the HomeLink system and simultaneously press and hold the button your are programming on the Infiniti system and the open button on the remote.
3. Release both buttons when the indicator light starts blinking quickly.
4. Press and hold the training button on the system until the indicator light glows solid. If the light continues blinking, complete the following steps.
5. Press the 'Smart' button on your garage door motor. This is usually on the back or the side of the motor near the switch codes and light lens.
6. Return to your vehicle and press the training button for two seconds, then press, hold and release it an additional two times. The indicator light should glow after this and the programming will be complete.