How to Replace a Driver#039;s Side Airbag in an Audi TT


1. Park the car and turn off its ignition. Open and secure the vehicle's hood. Locate the Audi's battery near the front of the engine compartment. Remove the negative battery cable from the battery terminal by loosening the cable's bolt with the wrench.
2. Open the driver's door and locate the fuse panel on the lower part of the dash, under the steering wheel. Pull out the fuse labeled 'Airbags' to fully deactivate the airbag system.
3. Unscrew the panels of your steering column with the screwdriver and carefully remove them. Locate the airbag inside the column. Loosen and remove the bolts holding the airbag in place, located behind the steering wheel, with the wrench. Pull the airbag out until you see the wires connecting it to the Audi's electrical wiring harness. Unplug the airbag from the wiring harness and discard the airbag.
4. Plug the wires of the replacement airbag into the car's wiring harness. Gently push the airbag into the column, ensuring that it does not twist up as you do so. Bolt the airbag in place behind the steering wheel. Replace the column panels and secure them with the screws.
5. Open the fuse panel and reinsert the airbag fuse. Reconnect the negative battery cable to its battery terminal and tighten it with the wrench. Close the Audi's hood.